MxPro 5 - General Routing InterfaceGeneral Routing Interface

The General Routing Interface General Routing interface Card is an optional module to provide fire routing outputs compliant with BS EN54-2: 1998 Clauses 7.9 and 8.9 and BS5839-1:2002

Applications / Limitations

EN54-2 compliant routing interfaces providing monitored outputs to fire alarm and routing circuits. Circuits are monitored for open and short circuit conditions in both normal and active mode - compliance with EN54-2 and BS5839-1: 2002 Clause 12.2.1a

The outputs will drive relay coils with impedances of between 1kΩ and 5kΩ.

Key Features

  • Two fire routing outputs are provided to differentiate between Call Point (MCP) and Automatic Detector (AFD) fire alarm signals if required.
  • Outputs are monitored for open and short circuit wiring issues in both the quiescent and active states, and fault conditions reported on the panel (CIE) display/LED Indicators.
  • Outputs are compatible with a wide range of routing equipment.
  • Simple to install and configure
  • Monitored outputs
  • Wide range compatibility
Specification
Output Circuit Spec.24V DC active, 5V DC monitor
Fire & Fault Outputs1.0mA monitor mode nominal, 5.0mA-25.0mA active (energised) mode dependent upon coil impendence, 40.0mA maximum short circuit.
Input Circuit Spec.4x Monitored Input - EOL 10KΩ, operating resistor 470Ω
Operating Voltage24V DC [Range 19-28V] from panel auxilliary Supply Output.
Panel Loading, standby, AC Mains fail (fault output off)43mA
Panel Loading, quiescent state (fault output on)45mA +24mA (1KΩ coil), +5mA (5KΩ coil)
Panel Loading, ALL inputs and outputs active48mA +72mA (1KΩ coils), +15mA (5kΩ coils)
On-boardIindications6x LED indicators for outputs active, communications and microprocessor heartbeat
Operating Temperature0°C to 50°C
ApprovalsBS EN54-2: 1998

Order Codes and Options

Mxp-532: General Routing Interface
Mxp-532F: General Routing Interface - Fitted

Compatibility

Can be used with all MxPro 5 series control panels programmed with version 50.07 software or later, compatible with the PC-Configuration tool from version 6.12 or later. The interface connects directly to peripheral bus connection in the panel.

 

Advanced Fire Systems

Our fire panels and systems are known all over the world for their leading performance, flexibility and ease of installation and use.