MxPro 5 - Peripheral Relay CardPeripheral Relay Card

The Peripheral Relay Card is a peripheral relay card providing 10 30V DC, 1A programmable relay outputs.

The Peripheral Relay Card connects directly to any of the DIL connectors of either the Network Mimic Mxp-020-100 LED Output Card, the general I/O controller Mxp-045 LED Output Card or the Multi-Way Input/Output card via the supplied ribbon cable.

Each output follows the cause-and-effect programming of the mimic unit output.

This can be either a simple zone output or can be an individually programmed output group rule utilising dynamic zoning.


These units can be used where many relay outputs are required for simple on/off signalling or control.

Key Features

  • Ten change-over contact outputs rated at 30V DC, 1A.
  • Up to 200 individual relay outputs fully programmable per mimic (excluding LEDs)
  • Ten individually programmable relay outputs per unit
  • DIN rail or screw fixing options
  • Separate isolate input (disables all outputs)
  • Separate isolate indication output
  • Fast instant response
Enclosure Dimensions H x W x D mmPCB: 90 x 160 x 15
Enclosure Dimensions H x W x D mmDIN rail: 90 x 160 x 40
DIN railModule mounts onto 32mm G Section and 35mm top hat (En50022) DIN rail
PCB Dimensions H x W x D mm35 x 142 x 70
Operating Temperature-5°C to 40°C
Relay Contacts10 volt free change over contacts
Contact Rating30V DC, 1A resistive
Power Supply (Card)24v DC nominal (21-28V DC)
Current (@24V DC)Quiescent: 0mA, relay on:13mA (per relay)
LED IndicationRelay circuit on (per relay)
Disable Control InputsVolt free input and mimic output drive option
Disable IndicationOpen collector output

Order Codes and Options

Mxp-052: 10 Way Relay Card
Mxp-046-DIN: 10 Way Relay Card in DIN Rail Carrier


Can be used with any of the mimic units or the Multi Way I/O units.


Advanced Fire Systems

Our fire panels and systems are known all over the world for their leading performance, flexibility and ease of installation and use.